General Help
Briggs & Stratton

FAQ SUPPORT

  • Ask a Question
  • Browse
  • Search
  • Search Tips

Topic Categories

  • Most Popular Answers
  • Maintenance
  • Parts
  • Replacement Engine
  • Specifications
  • Troubleshooting - Repairs
  • Other

RSS Feed Most Popular Answers

  • Electrical Schematic/Wiring Diagrams
  • Overhauling the Carburetor
  • Why won't my engine start?
  • Engine's RPM Fluctuates (Runs Rough)
  • Backfire/Antifire from Carburetor or Muffler
  • Engine Starts but then Shuts Down
  • Identifying a Briggs & Stratton Engine
  • Engine "Puffs" Smoke While It Runs
  • Oil Recommendations
  • Engine Problem Solving Tips
  • Antique Briggs & Stratton Literature/Information
  • Do you have a picture of where the governor linkage hooks up on my engine?
  • Obtaining/Ordering Parts List, Operator's Manuals/Literature
  • Air Filter Soaked with Oil
  • What would prevent an engine from starting?
  • Why will my engine run for 30 minutes and then shut off?
  • What is the age of my engine?
  • How can I identify which repair manual is for my engine?
  • How do I set up the governor's linkage/springs?
  • Engine Horsepower or Torque Rating
  • Why does the engine pull cord yank my arm back when I try to start my engine? (Kickback)
  • Why won't my engine stay at the same idle speed (runs rough) ?
  • Why does my engine lose power when I apply a load?
  • Why does my engine run only while I press the primer bulb or have the choke enga
  • What is the correct spark plug for my engine?
  • What is the direct replacement for my engine?
  • How did fuel get in my engine oil and how do I fix this?
  • Why will my engine run only with the choke applied?
  • What are the carburetor settings for my engine?
  • What are the oil recommendations for my engine?
  • Adjusting the Carburetor
  • Servicing the fuel tank
  • How do I time the valves?
  • Determining Part Numbers
  • Overhauling the Carburetor
  • Why does my engine backfire through the carburetor?
  • How do I change out the magnetron ignition coil?
  • Vertical Shaft Replacement Engine Specifications
  • Where can I get antique engine specifications?
  • Is synthetic oil approved for use in your engines?
  • Electrical Schematic/Wiring Diagrams
  • How do I troubleshoot poor engine performance?
  • Advanced Repair
  • Can I get engine specification information from your website?
  • Why does my engine backfire out the muffler?
  • Finding a Local B & S Warranty Repair Dealer
  • Identifying the correct spark plug and gap
  • Servicing the fuel filter
  • New Engine Series Labeling
  • Inspecting the anti-afterfire solenoid
  • Can I buy service parts online directly from the factory?
  • Adjusting The Governor
  • Why is my Quattro / Classic / Sprint engine hard starting/running rich?
  • Servicing The Valves
  • Servicing the Spark Plug
  • Replacing the Ignition
  • Engine Emits White/Blue Smoke While Running
  • Ignition System Theory and Testing
  • Ignition System
  • What would be the cause of gas coming out of the carburetor?
  • Horizontal shaft replacement engine specifications
  • How can I quiet down my engine?
  • Servicing the fuel pump
  • Fuel System
  • Fuel recommendations
  • Servicing air cleaners
  • Removing Carbon Deposits
  • What is the valve clearance for my engine?
  • Why doesn't my battery remain charged?
  • Governor System
  • Servicing the brake
  • Inspecting the flywheel & key
  • Engine does not start/runs poorly after storage
  • Engine does not appear to be producing spark
  • Why are there 2 oil fill plugs on my engine and which one do I use?
  • How much oil is required for my engine?
  • Inspecting & Changing The Muffler
  • Lubrication & Cooling System
  • Does Briggs & Stratton have a rebuild kit for their engines?
  • Why won't my engine start?
  • Engine operation/maintenance safety
  • Can I purchase parts/engines/short blocks factory direct?
  • Are Briggs & Stratton engines made in the U.S.?
  • What is the point gap on my engine?
  • Can I use unleaded gas with my engine?
  • Alternate (LP/NG , propane) fuel conversion
  • Can I use a car muffler?
  • B & S Liquid Cooled specifications
  • Compression System
  • Braking System
  • What would cause my engine to lock up?
  • Electrical System
  • Starter gear does not engage
  • What are your troubleshooting procedures for a stalling engine?
  • What are the recommended break-in procedures for my engine?
  • Testing the electrical system
  • Replacing the starter rope
  • Additional Maintenance
  • End-of-Season Maintenance
  • Does Briggs & Stratton make an adapter or kit to extend the muffler for outside
  • Removing Debris
  • Should I take my engine to a Briggs & Stratton Authorized Dealer or should I repa
  • Checking & Changing Oil
  • Why is the vacuum line to the fuel pump freezing up?
  • My owners manual and/or Illustrated Parts List (IPL) is not listed on your websi
  • Is camshaft on my engine driven by gears or a chain?
  • How much oil should an air cooled engine consume?
  • What caused my engine to blow-up/fail?
  • What is the purpose of the "sponge" in the gas tank?
  • What would cause the ignition module to fail on my engine?
  • Why isn't my battery charging properly?
  • What is the valve clearance for my engine?
  • Are there any troubleshooting/rebuilding/reassembly videos available? If so, ho
  • How do I become a Briggs & Stratton Authorized Dealer?
  • Can I install a starter motor in my engine?
  • At what condition would I need a high altitude jet for my carburetor?
  • Is there a bigger gas tank available for my engine?
  • Where can I purchase decals for my engine?
  • Why is the rubber primer bulb for my engine worn/broken?
  • Can I tap into the magneto's primary voltage to run lights?
  • How often should I change my oil?
  • What is the head bolt torque of my engine?
  • How do I drain the oil from my engine?
  • What is the charging voltage for my engine?
  • Replacing the Rewind
  • Can I add an electric starter to my engine?
  • What would cause pre-mature engine failure?
  • At what RPM's does my engine operate?
  • Can I get specification information on an engine via your website?
  • Do you have any engines that will power a go-kart (fun-kart)?
  • Can I vent the exhaust on my engine outside?
  • How do I remove the mount that the blade attaches to?
  • Where can I find the Manufacturers Suggested List Price on your engines, parts,
  • Does Briggs & Stratton manufacture the "self-propelled" portion of my lawn mower?
  • Do I need to register my engine with Briggs & Stratton in order to get warranty
  • What is my engine displacement?
  • Can my engine be converted for marine use?
  • Briggs & Stratton Warranty
  • How is my choke supposed to operate?
  • Where is the oil drain plug located on my engine?
  • Why is gasoline coming out of the vent tube by the air filter?
  • What would cause the rewind starter spring to break?
  • Is this a 2-stroke engine?
  • Regular Maintenance Schedule
  • Alternate (LP/NG , propane) fuel conversion
  • How do I change my oil filter?
  • How can I tell if I have a cast iron sleeve in the bore of my engine?
  • Do you have a price list for all of your parts?
  • What is the compression ratio for my engine?
  • Hang-tag Registration
  • Is my engine a cast iron engine?
  • What is the oil capacity of my engine sump?
  • How do I locate my nearest Briggs & Stratton Authorized Dealer?
  • How can I tell if I have an Industrial Commercial (I/C) engine?
  • How do I adjust various components on my lawnmower/rider/generator/tiller, etc.?
  • Gasoline Safety
  • Info for lawn mower/generator/tiller concerns
  • What accessories are available for my engine?
  • Why does my engine over heat?
  • What would cause damage to the cylinder walls?
  • Can I add a manual/rope starter to my existing engine?
  • Which is the correct literature for my engine?
  • Can an auxiliary drive shaft be added to my engine?
  • The dealer locator does not indicate a dealer in my area. How do I find another
  • At what altitude should I remove the main air bleed?

View All Results


 
Copyright © 2009 Briggs & Stratton. All rights reserved.